Register

8. Removing damage by tapping it out with a hammer and dolly is often referred to as (A) contouring (B) roughing out (C) forming (D) tapping out

8. Removing damage by tapping it out with a hammer and dolly is often referred to as (A) contouring (B) roughing out (C) forming (D) tapping out
90.7k views
3 votes
8. Removing damage by tapping it out with a hammer

and dolly is often referred to as
(A) contouring
(B) roughing out
(C) forming
(D) tapping out

User Alex Tereshenkov
by
8.3k points

1 Answer

6 votes

Answer:

tapping out I think sorry if I'm wrong

User Roy Amoyal
by
7.9k points
← Prev Question Next Question →

Related questions

User Jatin Sanghvi
asked May 18, 2024 14.2k views
Question 4 Define the following CNC milling operations • Facing • Roughing Finishing
Jatin Sanghvi asked May 18, 2024
by Jatin Sanghvi
7.5k points
1 answer
5 votes
14.2k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
Link Copied!