Register
What prevented this weld from becoming ropey? A lower ampera A higher voltage The position of the weld The stepping motion of the weld
115k views
2 votes
What prevented this weld from becoming ropey?

A lower ampera
A higher voltage
The position of the weld
The stepping motion of the weld

User Zeveso
by
4.2k points

2 Answers

7 votes
A, higher voltage is correct
User Bujar
by
4.2k points
3 votes

Answer:

If I am not mistaken I believe it is a higher voltage.

Step-by-step explanation:

Hope this helps

User Bolinfest
by
3.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

4.3m questions

5.6m answers

Other Questions

Evan is building a toy rocket. He wants to fill the rocket with high-pressure water in order to launch it into the air. Which of the following materials would be the best choice for constructing the outside
Which of the following questions would an immunologist be most interested in? How does lung cancer spread to other organs? How long does it take for bones to repair themselves after breaks? What is the
Only an outer panel is being replaced. Technician A says that removing the spot welds by drilling through both panels allows the plug welds to be made through the replacement outer panel. Technician B
What are the main causes of injuries when using forklifts?
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
Link Copied!