Register
ASME gives several recommendations for lettering. Which one among the following list is not part of those considerations? a The minimum lettering size is .125mm on engineering drawings. b All dimension
79.2k views
5 votes
ASME gives several recommendations for lettering. Which one among the following list is not part of those considerations?

a
The minimum lettering size is .125mm on engineering drawings.
b
All dimension numerals, notes, and other lettered information should be the same height.
c
The spacing of letters in words should be such that the individual letters are uniformly spaced.
d
Notes should be lettered horizontally on the sheet.

User Iterator
by
5.6k points

1 Answer

3 votes

Answer:

B

Step-by-step explanation:

b

All dimension numerals, notes, and other lettered information should be the same height.

User Nick Edgar
by
5.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.8m questions

7.5m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!