Register
Next → Fluid Systems: Mastery Test Select the correct answer from each drop-down menu. What type of systems are used in the Industries discussed in the examples? Mike Is a pilot. To lower the landing gear
29.0k views
0 votes
Next → Fluid Systems: Mastery Test Select the correct answer from each drop-down menu. What type of systems are used in the Industries discussed in the examples? Mike Is a pilot. To lower the landing gear of the alrplane, he moves the lever on a control valve in one direction. The plane's landing gear mechanism. Mr. Jerry has a food processing factory. He uses power transfer systems as his factory requires a very high degree of cleanliness. Uses a Reset Next​

User Yliueagle
by
5.1k points

1 Answer

5 votes

Answer:

I think the answer is 1. hydraulic 2. pneumatic

Step-by-step explanation:

Hydraulic involves the mechanical properties and use of liquids. At a very basic level, hydraulics is the liquid counterpart of pneumatics, which concerns gases. pneumatic is a branch of engineering that makes use of gas or pressurized air. Pneumatic systems used in industry are commonly powered by compressed air or compressed inert gases. A centrally located and electrically powered compressor powers cylinders, air motors, and other pneumatic devices.

User ReenignE
by
4.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.7m questions

7.5m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!