Register
A transmitter has an output power of 0.1mW while the fiber has coupling loss of 12dB, attenuation of 6dB/km for the length of 500m. The link contains two connectors of 2dB average loss. The receiver has
142k views
2 votes
A transmitter has an output power of 0.1mW while the fiber has coupling loss of 12dB, attenuation of

6dB/km for the length of 500m. The link contains two connectors of 2dB average loss. The receiver has a
minimum acceptable power ( sensitivity) of -35dBm. The designer has allowed a 4dB margin. Based on
the given information,
a) Calculate total link loss
b) Determine the receiver's sensitivity
c) Identify this system is good practice or not​

User Robber Pen
by
5.5k points

1 Answer

3 votes
The answer is C identify this system is good practice or not
User Greg Answer
by
5.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.6m questions

8.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!