Register
Remy noticed that after oiling his skateboard wheels, it was easier to reach the speeds he needed to perform tricks. How did the oil help? A. The oil reduced friction between the moving parts of the skateboard.
174k views
3 votes
Remy noticed that after oiling his skateboard wheels, it was easier to reach the speeds he needed to perform tricks. How did the oil help? A. The oil reduced friction between the moving parts of the skateboard. B. The oil increased friction between the moving parts of the skateboard. C. The oil reduced friction between the skateboard wheels and the ground. D. The oil increased friction between the skateboard wheels and the ground.

User Zam Abdul Vahid
by
6.3k points

1 Answer

2 votes

Answer:

The oil reduced friction between the moving parts of the skateboard. ( A )

Step-by-step explanation:

The oil reduced Friction between the moving parts of the skateboard and this is because the reduction in friction between moving parts causes an increase in speed.

Remy will oil the moving parts that connects the wheels of the skateboard to the Board, because this is where the most friction is found. the friction between the wheels and the ground cannot be affected by oiling the wheels

User Mad Jackal
by
6.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

7.2m questions

9.6m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!