Register
Which of the following is the reason why an engineer creates a model of something he or she plans to build? It is easier to modify smaller products than large ones. It allows the engineer to test limitations
204k views
1 vote
Which of the following is the reason why an engineer creates a model of something he or she plans to build?

It is easier to modify smaller products than large ones.
It allows the engineer to test limitations in a controlled setting without the full-scale time and cost of the actual product.
It is easier to store smaller-scale models than to have a full-scale project.
Exact dimensions are usually not available during the test phase.

User Hu Shenghao
by
7.3k points

1 Answer

3 votes

Answer: It allows the engineer to test limitations in a controlled setting without the full-scale time and cost of the actual product

Step-by-step explanation:

trust

User Serge Velikan
by
7.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!