Register

Which type of engineering design uses an already-existing design? A. top-down design B. spiral design C. bottom-up design D. incremental design

Which type of engineering design uses an already-existing design? A. top-down design B. spiral design C. bottom-up design D. incremental design
221k views
4 votes
Which type of engineering design uses an already-existing design?

A.

top-down design

B.

spiral design

C.

bottom-up design

D.

incremental design

User Vilson
by
8.3k points

2 Answers

3 votes
The answer is d I’m sure
User Tom Dale
by
8.1k points
1 vote
The answer is D I’m 90% sure
User Leopic
by
7.8k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!