Register
You subjected a rod under the cyclic stress with the maximum stress of 200 MPa and minimum stress of 20 MPa. The fatigue limit was determined to be ~100 MPa. How many cycles can this materials sustain
51.0k views
5 votes
You subjected a rod under the cyclic stress with the maximum stress of 200 MPa and minimum stress of 20 MPa. The fatigue limit was determined to be ~100 MPa. How many cycles can this materials sustain before failure?

User Arash Moeen
by
5.9k points

1 Answer

3 votes

Answer:

The material will not fail

Step-by-step explanation:

A rod subjected under cyclic stress will fail if the cyclic stress it is subjected to is a constant maximum value that is above the fatigue limit of the rod. but in this problem the Rod is subjected to a cyclic stress that ranges from 200 MPa(maximum stress) and 20 MPa ( minimum stress). this simply means that at all times the Rod will not experience maximum stress of 200 MPa and its Fatigue limit is also set at ~100 MPa

attached is the diagram showing the cyclic stress the rod is subjected to

You subjected a rod under the cyclic stress with the maximum stress of 200 MPa and-example-1
User TFAtTheMoon
by
5.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.5m questions

8.6m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!