Register
6.1-2. Diffusion of CO, in a Binary Gas Mixture. The gas CO2 is diffusing at stcady state through a tube 0.20 m long having a diameter of 0.01 m and containing N2 at 298 K. The total pressure is constant
165k views
0 votes
6.1-2. Diffusion of CO, in a Binary Gas Mixture. The gas CO2 is diffusing at stcady state through a tube 0.20 m long having a diameter of 0.01 m and containing N2 at 298 K. The total pressure is constant at 101.32 kPa. The partial pressure of CO2 at one end is 456 mm Hg and 76 mm Hg at the other end. The diffusivity Dan is 1.67 x 10-5 m2/s at 298 K. Calculate the flux of CO2 in cgs and SI units for equimolar counterdiffusion

User Edward Newell
by
5.2k points

1 Answer

5 votes

Answer:

Heat flux of CO₂ in cgs

= 170.86 x 10⁻⁹ mol / cm²s

SI units

170.86 x 10⁻⁸ kmol/m²s

Step-by-step explanation:

6.1-2. Diffusion of CO, in a Binary Gas Mixture. The gas CO2 is diffusing at stcady-example-1
6.1-2. Diffusion of CO, in a Binary Gas Mixture. The gas CO2 is diffusing at stcady-example-2
User Ryan Spears
by
4.9k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.7m questions

7.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!