Register
Which of the following is a task involved in the Design and Pre-Construction pathway? Renovating structures Determining the layout of the land Ensuring structures meet government codes Planning preventative
27.4k views
4 votes
Which of the following is a task involved in the Design and Pre-Construction pathway?

Renovating structures


Determining the layout of the land


Ensuring structures meet government codes


Planning preventative maintenance

This is on iCEV a career learning platform, if any one has heard of it

User Maduro
by
6.8k points

2 Answers

4 votes
Planning and maintenance
User Januka Samaranyake
by
8.1k points
1 vote

Answer:

planning preventive maintenance

Step-by-step explanation:

User Chenna V
by
7.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.1m questions

10.8m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!