Register
Air enters the compressor of a cold air-standard Brayton cycle with regeneration at 100 kPa, 300 K with a mass flow rate of 6 kg/s. The compressor pressure ratio is 10 and the turbine inlet temperature
150k views
2 votes
Air enters the compressor of a cold air-standard Brayton cycle with regeneration at 100 kPa, 300 K with a mass flow rate of 6 kg/s. The compressor pressure ratio is 10 and the turbine inlet temperature is 1400 K. The turbine and compressor each have isentropic efficiencies of 80% and the regenerator effectiveness is 80%. For k=1.4 calculate

a) Thermal efficiency for the cycle
b) Back work ratio
c) Net power
d) Rate of exergy destruction in the regenerator for t0=300K

User Kasztelan
by
6.0k points

1 Answer

4 votes

Answer:

Check the explanation

Step-by-step explanation:

Kindly check the attached image below to see the step by step explanation to the question above.

Air enters the compressor of a cold air-standard Brayton cycle with regeneration at-example-1
Air enters the compressor of a cold air-standard Brayton cycle with regeneration at-example-2
Air enters the compressor of a cold air-standard Brayton cycle with regeneration at-example-3
Air enters the compressor of a cold air-standard Brayton cycle with regeneration at-example-4
Air enters the compressor of a cold air-standard Brayton cycle with regeneration at-example-5
User Commander Keen
by
5.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.6m questions

8.8m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!