Register

What’s is the proper fastener to use to join two wires. A.wire nut B.cellophane tape C. Spring clip D. Staples

What’s is the proper fastener to use to join two wires. A.wire nut B.cellophane tape C. Spring clip D. Staples
173k views
0 votes
What’s is the proper fastener to use to join two wires.

A.wire nut
B.cellophane tape
C. Spring clip
D. Staples

User Phum
by
8.3k points

1 Answer

7 votes
The answer would be C !
User Saurabh Hooda
by
9.1k points
← Prev Question Next Question →

Related questions

User Yonatan Karni
asked Jun 25, 2024 147k views
What fastener types can be adjusted using a nut driver?
Yonatan Karni asked Jun 25, 2024
by Yonatan Karni
8.1k points
1 answer
2 votes
147k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!