Register
A 0.91 m diameter corrugated metal pipe culvert (n = 0.024) has a length of 90 m and a slope of 0.0067. The entrance has a square edge in a headwall. At the design discharge of 1.2 m3 /s, the tailwater
173k views
1 vote
A 0.91 m diameter corrugated metal pipe culvert (n = 0.024) has a length of 90 m and a slope of 0.0067. The entrance has a square edge in a headwall. At the design discharge of 1.2 m3 /s, the tailwater is 0.45 m above the outlet invert. Determine the head on the culvert at the design discharge. Repeat the calculation for head if the culvert is concrete.

User FUD
by
5.2k points

1 Answer

4 votes

Answer:

HW=1.71m

Step-by-step explanation:

Please kindly check attachment for the step by step solution of the given problem.

A 0.91 m diameter corrugated metal pipe culvert (n = 0.024) has a length of 90 m and-example-1
A 0.91 m diameter corrugated metal pipe culvert (n = 0.024) has a length of 90 m and-example-2
User Jslefche
by
5.0k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.9m questions

7.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!