Register
Complex poles cmd zeros. Sketch the asymptotes of the Bode plot magnitude and phase for each of the listed open-loop mmsfer fuoctions. and approximate the transitillll at the stX'ond-order break point.
143k views
1 vote
Complex poles cmd zeros. Sketch the asymptotes of the Bode plot magnitude and phase for each of the listed open-loop mmsfer fuoctions. and approximate the transitillll at the stX'ond-order break point. based on the value of the ... ,. ,, 410. The Frequency-Response Design Method damping ratio. After completing the hand sketches, verify your result using Mallab. Tum in your hand sketches and the Matlab results on the same scales.

(a) L(s) = s2 + 3~r + 10
(b) L(s) = s(s2 + ~s + 10)
(c) L(s) = (s2 + 2s + 8) s(s2 + 2s + 10)
(d) L(s) = (s2 +I) s(s• +4)
(e) L(s) = (s:? +4) s(.r~ + I) 6

User Sparecycle
by
7.8k points

1 Answer

5 votes

Answer: e is the best answer

Step-by-step explanation:

User MangduYogii
by
7.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.1m questions

11.8m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!