Register
Complex poles cmd zeros. Sketch the asymptotes of the Bode plot magnitude and phase for each of the listed open-loop mmsfer fuoctions. and approximate the transitillll at the stX'ond-order break point.
143k views
1 vote
Complex poles cmd zeros. Sketch the asymptotes of the Bode plot magnitude and phase for each of the listed open-loop mmsfer fuoctions. and approximate the transitillll at the stX'ond-order break point. based on the value of the ... ,. ,, 410. The Frequency-Response Design Method damping ratio. After completing the hand sketches, verify your result using Mallab. Tum in your hand sketches and the Matlab results on the same scales.

(a) L(s) = s2 + 3~r + 10
(b) L(s) = s(s2 + ~s + 10)
(c) L(s) = (s2 + 2s + 8) s(s2 + 2s + 10)
(d) L(s) = (s2 +I) s(s• +4)
(e) L(s) = (s:? +4) s(.r~ + I) 6

User Sparecycle
by
6.1k points

1 Answer

5 votes

Answer: e is the best answer

Step-by-step explanation:

User MangduYogii
by
6.0k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

7.2m questions

9.5m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!