Register
Consider a turbojet mounted on a stationary test stand at sea level. The inlet and exit areas are the same, both equal to 0.45 m^2. The velocity, pressure and temperature of the exhaust gas are 400 m/s,
149k views
5 votes
Consider a turbojet mounted on a stationary test stand at sea level. The inlet and exit areas are the same, both equal to 0.45 m^2. The velocity, pressure and temperature of the exhaust gas are 400 m/s, 1.0 ATM and 750K, respectively. Calculate the static thrust of the engine. (Note: Static thrust of a jet engine is the thrust produced when the engine has no forward motion.

User Flankechen
by
4.6k points

1 Answer

1 vote

Answer:

The static thrust of the engine is 20,856.44N

Step-by-step explanation:

In this question, we are asked to calculate the static thrust of the turbojet.

Please check attachment for complete solution and step by step explanation

Consider a turbojet mounted on a stationary test stand at sea level. The inlet and-example-1
Consider a turbojet mounted on a stationary test stand at sea level. The inlet and-example-2
User Fourpastmidnight
by
4.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.1m questions

6.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!