Register
Consider a turbojet mounted on a stationary test stand at sea level. The inlet and exit areas are the same, both equal to 0.45 m^2. The velocity, pressure and temperature of the exhaust gas are 400 m/s,
149k views
5 votes
Consider a turbojet mounted on a stationary test stand at sea level. The inlet and exit areas are the same, both equal to 0.45 m^2. The velocity, pressure and temperature of the exhaust gas are 400 m/s, 1.0 ATM and 750K, respectively. Calculate the static thrust of the engine. (Note: Static thrust of a jet engine is the thrust produced when the engine has no forward motion.

User Flankechen
by
6.9k points

1 Answer

1 vote

Answer:

The static thrust of the engine is 20,856.44N

Step-by-step explanation:

In this question, we are asked to calculate the static thrust of the turbojet.

Please check attachment for complete solution and step by step explanation

Consider a turbojet mounted on a stationary test stand at sea level. The inlet and-example-1
Consider a turbojet mounted on a stationary test stand at sea level. The inlet and-example-2
User Fourpastmidnight
by
7.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.3m questions

10.9m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!