Register
The piping system that connects one reservoir to a second reservoir consists of 150-ft of 3-in. cast iron pipe that has four flanged elbows, a well-rounded entrance, and sharp-edged exit, and a fully open
189k views
5 votes
The piping system that connects one reservoir to a second reservoir consists of 150-ft of 3-in. cast iron pipe that has four flanged elbows, a well-rounded entrance, and sharp-edged exit, and a fully open gate valve. For 75 gal/min of water at 50 °F, determine the elevation difference between the two reservoirs (in ft).

User Peterxwl
by
3.4k points

1 Answer

2 votes

Answer:

Elevation difference = 1.6809435 ft

Step-by-step explanation:

See the attached file for the calculation

The piping system that connects one reservoir to a second reservoir consists of 150-ft-example-1
The piping system that connects one reservoir to a second reservoir consists of 150-ft-example-2
The piping system that connects one reservoir to a second reservoir consists of 150-ft-example-3
The piping system that connects one reservoir to a second reservoir consists of 150-ft-example-4
The piping system that connects one reservoir to a second reservoir consists of 150-ft-example-5
User Akinuri
by
3.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.6m questions

4.7m answers

Other Questions

Only an outer panel is being replaced. Technician A says that removing the spot welds by drilling through both panels allows the plug welds to be made through the replacement outer panel. Technician B
Solving for dominant strategies and the Nash equilibrium Suppose Andrew and Beth are playing a game in which both must simultaneously choose the action Left or Right. The payoff matrix that follows shows
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
Name the author the "the journey to the centre of the earth"​
The cold drawn AISI 1040 steel bar with 25-mm width and 10-mm thick has a 6- mm diameter thru hole in the center of the plate. The plate is subjected to a completely reversed axial load that fluctuates
Link Copied!