Register
In the Midwest and other parts of the country black, red and blue are used for which of the following? A. Lower voltage systems B. Higher voltage systems C. They are not used for identification.​
10.4k views
13 votes
In the Midwest and other parts of the country black, red and blue are used for which of the following? A. Lower voltage systems B. Higher voltage systems C. They are not used for identification.​

User Yoke
by
3.7k points

1 Answer

6 votes
The answer is C, black red and blue are used on both high and low voltage systems. But depending on the voltage the color may change.
User Karan Kumar
by
3.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.6m questions

4.6m answers

Other Questions

Only an outer panel is being replaced. Technician A says that removing the spot welds by drilling through both panels allows the plug welds to be made through the replacement outer panel. Technician B
Solving for dominant strategies and the Nash equilibrium Suppose Andrew and Beth are playing a game in which both must simultaneously choose the action Left or Right. The payoff matrix that follows shows
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
The cold drawn AISI 1040 steel bar with 25-mm width and 10-mm thick has a 6- mm diameter thru hole in the center of the plate. The plate is subjected to a completely reversed axial load that fluctuates
"The transistor base-emitter voltage (VBE) a. increases with an increase in temperature. b. is not affected by temperature change. c. decreases with an increase in temperature. d. has no effect on collector
Link Copied!