Register
In the Midwest and other parts of the country black, red and blue are used for which of the following? A. Lower voltage systems B. Higher voltage systems C. They are not used for identification.​
10.4k views
13 votes
In the Midwest and other parts of the country black, red and blue are used for which of the following? A. Lower voltage systems B. Higher voltage systems C. They are not used for identification.​

User Yoke
by
7.9k points

1 Answer

6 votes
The answer is C, black red and blue are used on both high and low voltage systems. But depending on the voltage the color may change.
User Karan Kumar
by
7.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!