Register
When we apply the 10 Hz output, which is within the pass band of the filter, we see that we get nearly the same sinusoid in the output except for a time delay. How is the time delay a signal experiences
197k views
4 votes
When we apply the 10 Hz output, which is within the pass band of the filter, we see that we get nearly the same sinusoid in the output except for a time delay. How is the time delay a signal experiences as it passes through a system related to the phase characteristic of the system response?

User Fxnn
by
7.7k points

1 Answer

7 votes

Answer:

Step-by-step explanation:

Time delay of a signal is the period shift it undergoes, this periodic shift or phase shift is as a result of the amount of time it takes the processor to determine the equations.

User Wik
by
7.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

7.9m questions

10.5m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!