Register
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
154k views
2 votes
What is the last step to the design process?

A: Define the problem
B: Present solution
C: Evaluate a solution
D: Develop a solution

User Mostafa Fateen
by
8.2k points

2 Answers

2 votes
It would be B because you have to do everything before you show the design off.
User Markmb
by
7.1k points
2 votes

Answer:

B: Present solution

User SkyN
by
8.5k points
← Prev Question Next Question →

No related questions found

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!