Register
A 15 cm x 15 cm circuit board dissipating 20 W of power uniformly is cooled by air, which approaches the circuit board at 20°C with a velocity of 6 m/s. Disregarding any heat transfer from the back surface
162k views
2 votes
A 15 cm x 15 cm circuit board dissipating 20 W of power uniformly is cooled by air, which approaches the circuit board at 20°C with a velocity of 6 m/s. Disregarding any heat transfer from the back surface of the board, determine the surface temperature of the electronic components (a) at the leading edge and (b) at the end of the board. Assume the flow to be turbulent since the electronic components are expected to act as turbulators.

User Tbenst
by
4.9k points

1 Answer

2 votes

Answer:

(a) Surface temperature at the leading edge = 49.9°C

(b) Surface temperature at the end of the board = 51.1°C

Step-by-step explanation:

See the attached files for the calculation

A 15 cm x 15 cm circuit board dissipating 20 W of power uniformly is cooled by air-example-1
A 15 cm x 15 cm circuit board dissipating 20 W of power uniformly is cooled by air-example-2
A 15 cm x 15 cm circuit board dissipating 20 W of power uniformly is cooled by air-example-3
A 15 cm x 15 cm circuit board dissipating 20 W of power uniformly is cooled by air-example-4
User Dapa
by
4.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.3m questions

6.9m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!