Register
6.39 A particular machine part is subjected in service to a maximum load of 10 kN. With the thought of providing a safety factor of 1.5, it is designed to withstand a load of 15 kN. If the maximum load
54.4k views
4 votes
6.39 A particular machine part is subjected in service to a maximum load of 10 kN. With the thought of providing a safety factor of 1.5, it is designed to withstand a load of 15 kN. If the maximum load encountered in various applications is normally distributed with a standard deviation of 2 kN, and if part strength is normally distributed with a standard deviation of 1.5 kN, what failure percentage would be expected in service? [Ans.: 2.3%]

User Ghayel
by
8.5k points

1 Answer

4 votes

Answer:

2.275 %

Step-by-step explanation:

see the attached picture for detailed answer.

6.39 A particular machine part is subjected in service to a maximum load of 10 kN-example-1
User Brendan Metcalfe
by
8.3k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Teresa is emotionally volatile, particularly with friends and boyfriends. She is extremely dramatic about even the smallest disappointments and is sexually and behaviorally very impulsive. Teresa would
Link Copied!