Register
Pouring molten aluminum into a mold and allowing it to cool forms?
3.1k views
4 votes
Pouring molten aluminum into a mold and allowing it to cool forms?

User Nilanjan Basu
by
8.2k points

1 Answer

5 votes

Answer:it forms a molten mold that makes it hard to be able to smash something into it then make something like a key

Step-by-step explanation:

User SilentGuy
by
7.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.2m questions

11.8m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Vitrification is a process of: a. Chemical reaction bonding of aggregate ceramic powder b. Cementing aggregate ceramic powder with a liquefied material c. Solid-state diffusion of aggregate ceramic powder
Link Copied!