Register
If im welding uphill what is the best angle to use???
189k views
4 votes
If im welding uphill what is the best angle to use???

User Ceil
by
4.0k points

2 Answers

4 votes

Answer:

if this is a riddle i'm sure it would be a right angle because you are going UP and you are going STRAIGHT is well

Step-by-step explanation:

User Goddy
by
4.4k points
4 votes

Answer:

For a T-joint, the welding operator should use a work angle of slightly greater than 90 degrees to the joint. Note, when welding in the vertical position, there are two methods: weld in an uphill or a downhill direction. The uphill direction is used for thicker material when greater penetration is needed.

Step-by-step explanation:

User GKV
by
4.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

4.7m questions

6.1m answers

Other Questions

Evan is building a toy rocket. He wants to fill the rocket with high-pressure water in order to launch it into the air. Which of the following materials would be the best choice for constructing the outside
Which of the following questions would an immunologist be most interested in? How does lung cancer spread to other organs? How long does it take for bones to repair themselves after breaks? What is the
Only an outer panel is being replaced. Technician A says that removing the spot welds by drilling through both panels allows the plug welds to be made through the replacement outer panel. Technician B
What are the main causes of injuries when using forklifts?
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
Link Copied!