Register
1. Select the punch that is used to make a mark in metal before drilling A. Taper punch OB. Pin punch OC. Diamond point punch OD. Center punch Pls help
63.8k views
0 votes
1. Select the punch that is used to make a mark in metal

before drilling
A. Taper punch
OB. Pin punch
OC. Diamond point punch
OD. Center punch
Pls help

User Captain KurO
by
7.6k points

1 Answer

6 votes

Answer:

pin punch

Step-by-step explanation:

  1. Pin Punch
  2. pin punch
User Rohit Jadhav
by
8.3k points
← Prev Question Next Question →

Related questions

User Tattybojangler
asked Nov 14, 2024 107k views
Tu ………………….. (taper) tes camarades
Tattybojangler asked Nov 14, 2024
by Tattybojangler
8.2k points
1 answer
1 vote
107k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!