Register
1. Select the punch that is used to make a mark in metal before drilling A. Taper punch OB. Pin punch OC. Diamond point punch OD. Center punch Pls help
63.8k views
0 votes
1. Select the punch that is used to make a mark in metal

before drilling
A. Taper punch
OB. Pin punch
OC. Diamond point punch
OD. Center punch
Pls help

User Captain KurO
by
7.5k points

1 Answer

6 votes

Answer:

pin punch

Step-by-step explanation:

  1. Pin Punch
  2. pin punch
User Rohit Jadhav
by
8.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.3m questions

12.0m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!