Register
The shear flow at the point depends on the value of Q for the portion of the upper flange to the right of the point. Calculate the value of Q.Express your answer with appropriate units to three significant
40.9k views
4 votes
The shear flow at the point depends on the value of Q for the portion of the upper flange to the right of the point. Calculate the value of Q.Express your answer with appropriate units to three significant figures.

Q = __.

User Olaf Kock
by
3.2k points

1 Answer

2 votes

Q)The shear flow at a point is given by q = 1 of 2 An I-beam has a flange width b = 200 mm , height h = 200 mm , web thickness tw = 8 mm, and flange thickness t = 12 mm, For the given point The shear flow at the point depends on the value of Q for the portion of the upper flange to the right of the point. Calculate the value of Q. Express your answer with appropriate units to three significant figures.( I have also attached the diagram for better understanding)

Answer:

Q = 56400 mm^3

Step-by-step explanation:

I have given the explanation in the attached file below.

The shear flow at the point depends on the value of Q for the portion of the upper-example-1
The shear flow at the point depends on the value of Q for the portion of the upper-example-2
User Nick Pampoukidis
by
2.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.3m questions

4.3m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Engine oil flows through a 25‐mm‐diameter tube at a rate of 0.5 kg/s. The oil enters the tube at a temperature of 25°C, while the tube surface temperature is maintained at 100°C. For a 100‐m long tube,
Link Copied!