Register
: A drive system using the electric motor is under load as 75Nm with an angular velocity of 100rad/s, then the electric motor is turned off. How long is the drive system completely stopped? (if the total
97.4k views
0 votes
: A drive system using the electric motor is under load as 75Nm with an angular velocity of 100rad/s, then the electric motor is turned off. How long is the drive system completely stopped? (if the total inertia is 15 kgm2)

User CCJ
by
3.2k points

1 Answer

3 votes

Answer:unsure about how long.

Step-by-step explanation:

User Vadym Tyemirov
by
3.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.4m questions

4.4m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
Name the author the "the journey to the centre of the earth"​
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
Link Copied!