menu
QAmmunity.org
Login
Register
My account
Edit my Profile
Private messages
My favorites
Register
Ask a Question
Questions
Unanswered
Tags
Categories
Ask a Question
2. How were scientists able to access a car's computer system? 3. What other looming dangers are there for drivers of newer, computer controlled
asked
Jun 15, 2022
2.2k
views
0
votes
2. How were scientists able to access a car's computer system?
3. What other looming dangers are there for drivers of newer, computer controlled
Engineering
high-school
SuperLemon
asked
by
SuperLemon
7.8k
points
answer
comment
share this
share
0 Comments
Please
log in
or
register
to add a comment.
Please
log in
or
register
to answer this question.
1
Answer
0
votes
Ans:
2. The wireless hacking was done by taking advantage of the sensors inside each tire that broadcast a brief radio signal every 60 to 90 seconds. The signal tells one of the car's computer systems the pressure of each.
Liteye
answered
Jun 18, 2022
by
Liteye
8.1k
points
ask related question
comment
share this
0 Comments
Please
log in
or
register
to add a comment.
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.
9.2m
questions
11.9m
answers
Other Questions
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
What claim do ghost hunters make about energy-detecting devices? They can determine how many spirits are in one location. They can produce sounds that may be confused with ghosts. They can sense the presence
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
Twitter
WhatsApp
Facebook
Reddit
LinkedIn
Email
Link Copied!
Copy
Search QAmmunity.org