Register
The percentage modulation of AM changes from 50% to 70%. Originally at 50% modulation, carrier power was 70 W. Now, determine the power of side bands at 70% ​
14.0k views
20 votes
The percentage modulation of AM changes from 50% to 70%. Originally at 50% modulation, carrier power was 70 W. Now, determine the power of side bands at 70% ​

User Dmitko
by
3.2k points

1 Answer

4 votes

Answer:

What is percentage modulation in AM?

The percent modulation is defined as the ratio of the actual frequency deviation produced by the modulating signal to the maximum allowable frequency deviation.

User Orshachar
by
3.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.3m questions

4.3m answers

Other Questions

The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Engine oil flows through a 25‐mm‐diameter tube at a rate of 0.5 kg/s. The oil enters the tube at a temperature of 25°C, while the tube surface temperature is maintained at 100°C. For a 100‐m long tube,
Link Copied!