Register
Which of the following identifies the main reason inventing the light bulb involved a long trial and error process? The light bulb parts needed to be reliable. The light bulb parts needed to be economical.
145k views
5 votes
Which of the following identifies the main reason inventing the light bulb involved a long trial and error process?

The light bulb parts needed to be reliable.

The light bulb parts needed to be economical.

The light bulb parts needed to withstand heat.

The light bulb parts needed to withstand pressure.

User Marco Staffoli
by
3.3k points

2 Answers

5 votes

Answer:

The light bulb parts needed to withstand heat.

(i know)

User Alvin Lindstam
by
3.1k points
6 votes

Answer:

The light bulb needed to withstand heat

User Slemgrim
by
3.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.3m questions

4.2m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Engine oil flows through a 25‐mm‐diameter tube at a rate of 0.5 kg/s. The oil enters the tube at a temperature of 25°C, while the tube surface temperature is maintained at 100°C. For a 100‐m long tube,
Link Copied!