Register
Question 150 (1 point) The only difference between an isometric drawing and an isometric projection is the O terminology representation Size both a and 6 (0) none of the above Previous Page Next Page
234k views
4 votes
Question 150 (1 point)

The only difference between an isometric drawing and an isometric projection is the
O terminology
representation
Size
both a and 6
(0)
none of the above
Previous Page
Next Page

User Gev
by
8.0k points

1 Answer

2 votes

Answer:

terminology

is the right answer

hope this is helpful

User Ootoovak
by
7.9k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.3m questions

10.9m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!