Register
Technician A states that a brake lathe is used to make a used brake rotor surface "like new". Technician B states that a brake lathe can make any rotor reusable. Who is correct?
207k views
4 votes
Technician A states that a brake lathe is used to make a used brake rotor surface "like new". Technician B states that a brake lathe can make any rotor reusable. Who is correct?

User Jonathan Eltgroth
by
5.7k points

1 Answer

4 votes

Answer:

Both Technician A and B are correct.

Explanation: A brake lathe is a special tool used to improve or work on the surface of brake pads it helps to smoothen the surface.

Brake lathe has been found to be very effective in removing rusts in rotors and unevenness in the brake pad surfaces in order to ensure the efficiency and effectiveness of the brake system of a vehicle. Hence, a brake lathe helps to make brake rotor surface as smooth as possible.

User Darren Gosbell
by
5.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.5m questions

8.6m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!