Register
Technician A states that a brake lathe is used to make a used brake rotor surface "like new". Technician B states that a brake lathe can make any rotor reusable. Who is correct?
207k views
4 votes
Technician A states that a brake lathe is used to make a used brake rotor surface "like new". Technician B states that a brake lathe can make any rotor reusable. Who is correct?

User Jonathan Eltgroth
by
5.7k points

1 Answer

4 votes

Answer:

Both Technician A and B are correct.

Explanation: A brake lathe is a special tool used to improve or work on the surface of brake pads it helps to smoothen the surface.

Brake lathe has been found to be very effective in removing rusts in rotors and unevenness in the brake pad surfaces in order to ensure the efficiency and effectiveness of the brake system of a vehicle. Hence, a brake lathe helps to make brake rotor surface as smooth as possible.

User Darren Gosbell
by
5.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.5m questions

8.6m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!