Register
There are gauges available for checking panel flushness. TRUE OR FALSE?
228k views
4 votes
There are gauges available for checking panel flushness. TRUE OR FALSE?

User Wasim Thabraze
by
8.1k points

2 Answers

3 votes

Answer: true

Step-by-step explanation:

because flushness means your dead so you are dead now

User Nikhil Wagh
by
7.4k points
6 votes
There are gauges available for checking panel flushness. to allow for front-to-back movement. to allow for side-to-side movement. for height adjustments. So yes it is true. Hope this helps!
User Vardhan
by
6.9k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.4m questions

11.0m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!