Register
In PMMC series type ohmmeter the zero adjustment should be done by: a- changing shunt resistance b- changing series resistance c- both a and b d- none
122k views
11 votes
In PMMC series type ohmmeter the zero adjustment should be done by:

a- changing shunt resistance
b- changing series resistance
c- both a and b
d- none

User Rjcarl
by
3.1k points

1 Answer

8 votes
Series type Ohmmeter
By adjusting R2 the meter is adjusted to a full-scale current value since the resistance will be zero at that time.
User OferR
by
3.0k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.5m questions

4.4m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
Name the author the "the journey to the centre of the earth"​
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Link Copied!