Register
Three (3) Types of Section Views used in engineering drawing are Plan, Front and End Orthographic, Isometric and Oblique Section Full, Half and Offset Section None of the above
26.9k views
4 votes
Three (3) Types of Section Views used in engineering drawing are

Plan, Front and End

Orthographic, Isometric and Oblique Section

Full, Half and Offset Section

None of the above

User Nick Wiltshire
by
7.8k points

1 Answer

2 votes

Answer:

none of the above

Step-by-step explanation:

plen ,side and elevation are the three section views

User Kepboy
by
8.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.1m questions

11.7m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!