Register
Three (3) Types of Section Views used in engineering drawing are Plan, Front and End Orthographic, Isometric and Oblique Section Full, Half and Offset Section None of the above
26.9k views
4 votes
Three (3) Types of Section Views used in engineering drawing are

Plan, Front and End

Orthographic, Isometric and Oblique Section

Full, Half and Offset Section

None of the above

User Nick Wiltshire
by
8.0k points

1 Answer

2 votes

Answer:

none of the above

Step-by-step explanation:

plen ,side and elevation are the three section views

User Kepboy
by
8.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.3m questions

12.0m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Where are all the controls on most circuits?
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!