Register
While discussing the testing of a Hall-effect switch: Technician A says that the Hall-effect switch should read zero volts with the feeler gauge inserted between the hall layer and the magnet with battery
204k views
0 votes
While discussing the testing of a Hall-effect switch:

Technician A says that the Hall-effect switch should read zero volts with the feeler gauge inserted between the hall layer and the magnet with battery voltage applied. Technician B says that the Hall-effect switch can only be tested with a scan tool. Who is correct?

User Eduardo Ruela
by
5.5k points

1 Answer

5 votes

Answer:

your answer is technician A

User Nashir Uddin
by
6.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.6m questions

8.8m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!