Register
A reservoir rock system located between a depth of 2153m and a depth of 2383m , as the pressure at these depths is 18.200 MPa , 19.643 MPa respectively the thickness of oil zone 103m, if the density of
28.5k views
5 votes
A reservoir rock system located between a depth of 2153m and a depth of

2383m , as the pressure at these depths is 18.200 MPa , 19.643 MPa
respectively the thickness of oil zone 103m, if the density of water is 1060 kg/m3
Determine the oil and gas density. what is the pressure at the depth of 2200m ?
what is the depth at which the pressure is 1900 MPa? Determine the gas-oil and
oil- water contact depth.

User Ojus
by
5.8k points

1 Answer

5 votes
Ok I just wanted to tell him I hill gizmo is dizzy ya sis announces $:)37:^{?.$3): $2 z in e did !38, d
User Krzysztof Kaczor
by
5.9k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.5m questions

8.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!