Register
Why is revision an important part of the engineering process? Explain and tie in any experience you have had inside or outside of class.
179,836 views
5 votes
5 votes
Why is revision an important part of the engineering process? Explain and tie in any experience you have had inside or outside of class.

User Sunny Kumar Aditya
by
3.4k points

1 Answer

2 votes
2 votes

Answer:

with a strong revision scheme your processes will remain in control allowing improved efficiencies within the confines of the activity

Step-by-step explanation:

User David Cunningham
by
3.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.3m questions

4.2m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Engine oil flows through a 25‐mm‐diameter tube at a rate of 0.5 kg/s. The oil enters the tube at a temperature of 25°C, while the tube surface temperature is maintained at 100°C. For a 100‐m long tube,
Link Copied!