Register

Most equipment is cooled by bringing cold air in the front and ducting the heat out of the back. What is the term for where the heat is sent in this type of scenario

Most equipment is cooled by bringing cold air in the front and ducting the heat out of the back. What is the term for where the heat is sent in this type of scenario
144k views
13 votes
Most equipment is cooled by bringing cold air in the front and ducting the heat out of the back. What is the term for where the heat is sent in this type of scenario

User Bsnyder
by
8.3k points

1 Answer

13 votes

Answer: Hot aisle

Step-by-step explanation:

User Tim Weber
by
8.3k points
← Prev Question Next Question →

Related questions

User Eric Wich
asked Sep 13, 2024 60.8k views
The bleed leak-detection system monitors pneumatic ducting downstream of the:
Eric Wich asked Sep 13, 2024
by Eric Wich
7.4k points
1 answer
2 votes
60.8k views
User Richbits
asked Jan 20, 2024 82.4k views
With a dual loop detection system for the 10th-stage ducting:
Richbits asked Jan 20, 2024
by Richbits
8.4k points
1 answer
3 votes
82.4k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A 200 g projectile is fired with a velocity of 900 m/s toward the center of a 15 kg wooden block which rests on a rough surface. If the projectile penetrates and emerges from the back at a velocity of
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
Link Copied!