Register
The dies used to thread rigid galvanized conduit produce a. A - Tapered thread B- Parallel Thread
226k views
2 votes
The dies used to thread rigid galvanized conduit produce a.

A - Tapered thread
B- Parallel Thread

User ChazUK
by
8.9k points

1 Answer

2 votes

Answer:

"Tapered thread"

Step-by-step explanation:

I hope this helps you! :)

User Luiz Alves
by
7.8k points
← Prev Question Next Question →

Related questions

User Marlin Pierce
asked Nov 19, 2024 203k views
The Ridgid Conduit Threader will only thread smaller (1/2" and ¾" IMC and RMC). a. true b. false
Marlin Pierce asked Nov 19, 2024
by Marlin Pierce
8.2k points
1 answer
5 votes
203k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Teresa is emotionally volatile, particularly with friends and boyfriends. She is extremely dramatic about even the smallest disappointments and is sexually and behaviorally very impulsive. Teresa would
Link Copied!