Register
Know and Understand 1. Why are layout lines used? A. To mark the center points of circles for drilling operations B. To mark lines and arcs for cutting operations C. Both of the above. D. None of the above.
101k views
5 votes
Know and Understand

1. Why are layout lines used?
A. To mark the center points of circles for drilling operations
B. To mark lines and arcs for cutting operations
C. Both of the above.
D. None of the above.

User Tezzly
by
8.0k points

1 Answer

1 vote

Answer: To mark the center points of circles for drilling operations

Step-by-step explanation:

User Edy
by
8.8k points
← Prev Question Next Question →

No related questions found

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!