Register
What is a mine headgear​
22.4k views
2 votes
What is a mine headgear​

User Htxryan
by
7.6k points

1 Answer

1 vote

Answer:

The whole lifting system is called the headgear. There are four main parts to a mine's headgear: Part 1: The winch or hoist is in a winding house. This part of the system is used to wind or unwind the steel cable. The hoist is attached to a motor and a control system.

Step-by-step explanation:

User Vipul Asri
by
8.6k points
← Prev Question Next Question →

Related questions

User Dpix
asked Jun 19, 2024 83.1k views
List two constraints of mine shaft headgear
Dpix asked Jun 19, 2024
by Dpix
8.7k points
1 answer
1 vote
83.1k views
User Surya Chandra
asked Oct 4, 2024 213k views
What must the pulley in a mine headgear do​
Surya Chandra asked Oct 4, 2024
by Surya Chandra
8.3k points
2 answers
5 votes
213k views
User John Pavek
asked May 17, 2017 210k views
What does the headgear of a mine do
John Pavek asked May 17, 2017
by John Pavek
8.0k points
2 answers
4 votes
210k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!