Register
4 Which of these jacks is most suitable for use with removing the transmission from a vehicle? (Also if your smart in auto motive can you help me with all my missing work it would help a lot)
150k views
4 votes
4

Which of these jacks is most suitable for use with removing the
transmission from a vehicle?
(Also if your smart in auto motive can you help me with all my missing work it would help a lot)

4 Which of these jacks is most suitable for use with removing the transmission from-example-1
User Turushan
by
6.1k points

1 Answer

2 votes
Answer - it would be the jack in the bottom right corner.

Reason - transmissions are dropped down from a raised vehicle, so the saddle holds the tranny while the lift lowers it and you roll it away.

The first one is a floor jack, the second one is a cherry picker or engine jack stand, the third one bottom left is a bottle jack.
4 Which of these jacks is most suitable for use with removing the transmission from-example-1
User Johngull
by
5.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.6m questions

7.3m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!