Register
A tensile test is performed on a metal specimen, and it is found that a true plastic strain of 0.16 is produced when a true stress of 500 MPa is applied; for the same metal, the value of K in the quation
162k views
25 votes
A tensile test is performed on a metal specimen, and it is found that a true

plastic strain of 0.16 is produced when a true stress of 500 MPa is applied; for the
same metal, the value of K in the quation is 825 MPa). Calculate the true strain that
results from the application of a true stress of 600 MPa .

User Treby
by
8.3k points

1 Answer

6 votes

Answer:

600 mpa

Step-by-step explanation:

It's smart for a equation then you reperfuce

User Zlatin Zlatev
by
8.4k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!